Fisher & Paykel BGB36-BQAR User Manual

Radiant Assembly
Details installing the grease shields and radiant assembly installation.
Installing The Grease Shields
The grease shields (2 per burner) help deflect any
grease drippings away from the grill burner ports,
preventing the ports from getting clogged. They
come packed with the other accessories, in a
separate bag.
Unpack the grease shields and position them on
the pins above the grill burners (two per burner),
as shown in Fig. 24.
Radiant Assembly Installation:
1. Unpack ceramic rods and remove radiant (Fig.
25) from the unit.
2. Unlock radiant end cap by pushing it up with
two fingers (Fig. 26).
3. Place 18 ceramic rods on the radiant (Fig. 27).
4. Lock radiant end cap (Fig. 28).
5. Place the assembled radiant in the unit (Fig.
29).
FIG. 24 Grease shields
https://producthelp.fisherpaykel.com/au/Grill/Built-In_Grills/BGB36-BQAR/User_Guide_BGB36-BQAR/08_Radiant_Assembly
Updated: Fri, 07 Apr 2023 15:10:33 GMT
Powered by
1

Fisher & Paykel BGB36-BQAR Specifications

General

Model Number	BGB36-BQAR
Category	Grill
Type	Built-In
Size	36 inches
Fuel Type	Natural Gas
Burners	4
Material	Stainless Steel
Ignition System	Electronic

Summary

Radiant Assembly

Installing The Grease Shields

Grease shields deflect grease drippings from burner ports to prevent clogging. They are packed separately.

Radiant Assembly Installation

Steps for installing the radiant assembly, including ceramic rods and end caps, as shown in figures.

Ceramic Rod Maintenance

Replacing a Broken Ceramic Rod

Steps to replace a broken ceramic rod, including end cap manipulation and rod replacement.