Fisher & Paykel CG903ML - Introduction; Introducing your cooktop; Before using your cooktop

REMOVE FROM PACKAGING ENSURE THERE IS ADEQUATE AIR SUPPLY
FIT THE ELBOW & FLEXIBLE HOSE LOWER GENTLY INTO THE CUTOUT
87
19 0
PTFE
” NPT
1
2
1
1
2
A
Ensure there is enough
exible hose looped to
allow for removing
appliance for servicing.
A
Important!
The exible hose supplied
must be used to enable servicing.
500 mm
50 mm
A A
The CookSurface requires adequate air supply to fully function. The base of the CookSurface must have direct
unrestricted ventilation to the room where the CookSurface is installed. Do not ventilate the base area to an
external area that can be at dierent air pressure to that of the burners. You may ventilate from adjacent
cupboards, but ensure that the available air supply will not be restricted. The ventilation area must be
500 x 50 mm or of an equivalent area. If the 50 mm wide slot is not possible due to the width of the available toe
recess, increase the length of the slot so as to maintain an equivalent area of 250 cm
2
. An air intake grill is provided.
Ensure that the grill is not covered or obstructed.