• Add three cups of water into the drawer. Press
until the indicator of the ‘Rinse’ program lights up. Close the drawer and press
to start the program. Repeat for the other drawer.
• When the test cycle is in process check the knock sensor is working by knocking twice on the door to pause the
wash program.
• After the Rinse program has finished, ensure the dishwasher has run and drained correctly.
• Check the water supply has correctly shut off and drainage connection for leakage.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Integrated_Double/DD24DTI9_N/Installation_Guide_…
Updated: Tue, 16 Nov 2021 11:39:38 GMT
Powered by
2
To Previous Page
Loading...
Need help?
General
