24
Water softener
Notes:
If your water hardness is above 625ppm, we highly recommend you completely fill the
appropriate compartment(s) of the detergent dispenser for all programmes except Rinse and the
rinse aid setting should be at 5. If your water hardness is above 625ppm, the wash performance
of your DishDrawer® will decline.
You may hear some unusual noises when the water softener is in operation, this is normal.
How to fill the salt reservoir
1
Open the DishDrawer®.
2
Unscrew the salt reservoir cap by turning anticlockwise.
3
Place the salt into the salt container and pour the contents into the salt reservoir. The salt
reservoir can hold up to approximately 1 lb/0.5 kg of salt.
4
Fit the cap tightly back into its original position.
5
If you do not wash your dishes immediately after filling the salt reservoir, run a Rinse programme
to remove any salt water or spilt granules.
Note:
When filling the salt reservoir, you may notice water being displaced from the water softener
overflow.
Salt
container
Salt
reservoir
To Next Page
Loading...
Need help?
General
