43
Troubleshooting
Problem Possible causes What to do
Water has poor
taste/odour.
Refrigerator not used for an
extended period.
Dispense 3 L (3 qt) water so fresh water
supply is replenished.
Water dispenser
does not work
and/or
icon
flashing.
Water supply turned off or not
connected.
Turn water on.
Press dispenser for 2 mins to remove
trapped air from water line and to fill
the water system.
Supply line may be blocked.
On first installation there may be
air in water system.
Check supply for kinks or leaks.
To remove air, run a litre or a quart of
water through the dispenser.
Filter may be blocked and need
replacing.
Replace filter (see back of this booklet
for Customer Care contact details).
Dispenser lock activated.
Hold down the
and button for 2
seconds.
Water frozen in tank. Increase temperature to a warmer
setting in fresh food compartment and
freezer.
Water in first glass
is warm.
Water dispenser not used for
extended period.
Allow 24 hrs for water to cool to set
temperature.
Tank capacity used recently. Allow water time to cool.
Filter warning light
is flashing.
Filter needs replacing. Replace filter as soon as possible (refer
to pages 28 – 29).
Measured Fill
amount of water is
inaccurate.
Measured Fill needs
recalibration.
Recalibrate (refer to page 30).
Drips overflow
drip-shelf.
Air trapped in tank. Flush 3 L (3 qt) water through
dispenser, stopping intermittently.
New filter installed. Flush 3 L (3 qt) water through filter and
then 3 L (3 qt) through dispenser.
To Next Page
Loading...
