Why is my Fisher & Paykel Washer not turning on?
Your Fisher & Paykel Washer may not be turning on because the power is not switched on at the wall. To resolve this, switch the power on at the wall and then press the power button on the washer.
Why is my Fisher & Paykel WL8058G1 not spinning properly?
If your Fisher & Paykel Washer is not spinning properly, it could be due to an unbalanced load. Pause the washer and manually redistribute the load. Also, check that the washer is level and does not rock in any direction.
What to do if my Fisher & Paykel WL8058G1 is not filling with water?
If your Fisher & Paykel Washer is not filling with water, here are a few things to check: * Make sure both the hot and cold inlet taps are turned on. * Clear any blockages from the inlet hose filters. * Ensure that the DELAY START function is not activated.
Why is my Fisher & Paykel WL8058G1 Washer continually going out of balance?
If your Fisher & Paykel Washer is continually going out of balance, it could be due to a few reasons: * The washer may not be level, so ensure it is stable and does not rock. * Ensure the load size is less than the stated capacity for that cycle.
What to do if my Fisher & Paykel WL8058G1 is filling continuously?
If your Fisher & Paykel Washer is filling continuously, ensure the drain hose is correctly installed in the standpipe or tub. To prevent siphoning, make sure the drain hose does not extend more than 20 mm from the end of the hose guide.
Why is there too much or too little water when filling my Fisher & Paykel WL8058G1 Washer?
If there is too much or too little water when filling your Fisher & Paykel Washer, it may be because the machine has been set to a Manual water level rather than Auto. Ensure Auto Water Level is set rather than setting the water level yourself.
How to stop creasing in my Fisher & Paykel Washer?
To reduce creasing in your Fisher & Paykel Washer, consider the following: * Reduce the load size. * Choose the EASY IRON cycle, which is designed to minimize creasing. * Select a lower spin speed. * Select a lower wash temperature.
Why are there too many soap suds in my Fisher & Paykel WL8058G1?
Too many soap suds in your Fisher & Paykel Washer may be due to using an incorrect detergent. Ensure you are using a Low Suds detergent. You might also try using a little less detergent, especially if the garments are only lightly soiled.
Why is there detergent residue on clothes after washing in my Fisher & Paykel WL8058G1 Washer?
Detergent residue on clothes after washing in your Fisher & Paykel Washer can be caused by overloading the washer. Try reducing your load size. It may also be due to incorrect detergent dosage, so try using less detergent.
How to prevent dye transfer in my Fisher & Paykel WL8058G1?
To prevent dye transfer in your Fisher & Paykel Washer, wash and dry non-colourfast clothes separately. Non-colourfast clothes left sitting in a washer or laundry basket can transfer dye onto other clothes.
General| Brand | Fisher & Paykel |
|---|---|
| Model | WL8058G1 |
| Category | Washer |
| Language | English |
To Next Page
