Slide the power switch to OFF when
finished playing.
Turning off the Code-a-pillar Twist
3
5
Run the Code-a-pillar Twist
4
Press the GO! button. It will take a few seconds for Code-a-pillar to process your request.
Hint: The GO! button is the only button on Code-a-pillar. The segment pieces do not have buttons.
Ending a code sequence/program
The code sequence has ended when the Code-a-pillar stops and sings its "code"
song.
The Code-a-pillar’s pieces will light up as it maps out the “programmed” mission you coded.
Once it knows the mission, off it goes!
To Previous Page
Loading...
Need help?
General
