To Next PageTo Next PageHow to fix Fisher-Price THOMAS & FRIENDS engine that doesn't move or talk?
If your Fisher-Price Toy engine isn't moving or talking, it might be in sleep mode due to inactivity or paused. Press the button on the engine to wake it up. Also, check the batteries; if they're dead, replace them with two new AAA alkaline batteries.
What to do if Fisher-Price THOMAS & FRIENDS engines do not react to each other?
If your Fisher-Price Toy engines aren't reacting to each other, consider these potential causes: * Low battery power: Replace the batteries in both engines with two new AAA alkaline batteries. * Excessive distance: Ensure the engines are no more than six feet (1.8 meters) apart. * Bright light interference: Try dimming the lights in the room by closing curtains or turning off a light. * Sleep mode: Press the button on each engine to wake them up if they have been inactive for about five minutes.
Why Fisher-Price THOMAS & FRIENDS Toy engine talks and blinks but doesn't move?
If your Fisher-Price Toy engine talks and its front light blinks three times, but it doesn't move, be sure to replace the batteries with two new AAA alkaline batteries.
Why does one Fisher-Price THOMAS & FRIENDS engine stop and talk when the other stops?
If the button on one Fisher-Price Toy engine is pressed to pause movement, or if it's stopped on a stop track, a loading station, or Brendan Dock, the other engine stops to chat and then starts moving again.
Why an engine from another set does not work on track in this Fisher-Price THOMAS & FRIENDS Toy set?
Only talking engines will interact with engines included with this Fisher-Price Toy set.
How to turn off Fisher-Price THOMAS & FRIENDS Toy engines completely?
To completely turn off the power of your Fisher-Price Toy engines, press and hold the button on each engine for about three seconds.
General| Brand | Fisher-Price |
|---|---|
| Model | THOMAS & FRIENDS |
| Category | Toy |
| Language | English |
Assembly steps marked with a star indicate permanent assembly.
Insert boulder holder tabs into Blue Mountain by squeezing tabs.
Open the gate by pressing the windmill top.
Position stop tracks and loading station to 'Stop' for initial setup.
Turn engines ON by pressing buttons, then use levers to GO.
Utilize switch tracks to guide engine direction on the layout.
Engines will interact and recognize each other at the loading station.
Boulder falls into cargo car when engine passes through tunnel.
Lower Cranky's hook to pick up lobsters when engine stops.
Rotate Cranky to move the lobster crate.
Release the engine by flipping a lever.
Engine stops at Brendam Docks when Bulstrode is docked.
Release the engine by launching Bulstrode.
Windmill blades spin when the engine opens the gate.
Press windmill top to spin blades; close gate to activate.
Important safety guidelines for battery usage and disposal.
Compliance statement regarding FCC rules for digital devices.
Canadian interference regulations for electronic devices.
