H (Ceiling height)
Ceiling
2mm
m
34mm
10-1
136m
Chart 6
Bolt
Chart 7
Central hole
Bolt M6X12
Installation paper board
B. New built houses and ceilings
a. In the case of new built house, the hook can be embedded in advance (refer to the A.b mentioned above).
But it should be strong enough to bear the indoor unit and will not become loose because of concrete shrinking.
b. After installing the body, please fasten the installation paper board onto the air conditioner with bolts
(M6X12) to determine in advance the sizes and positions of the hole opening on ceiling. Please first guarantee the
flatness and horizontal of ceiling when installing it.Refer to the A.a mentioned above for others.
c. Refer to the A.c mentioned above for installation.
d. Remove the installation paper board.
(2) Install The Panel
1) Remove the inlet grid.
a. Slide two grid switches toward the middle at the same time, and then pull them up. (Refer to chart 8)
b. Draw the grid up to an angle of about 45, and remove it. (Refer to chart 9)
Grid switch
Chart 8
4
5
Chart 9 Chart 10
To Next Page
Loading...
