Lit. No. 49599, Rev. 05 6 April 1, 2018
29250, 29350, 97000, 97000-1, 97100, 97100-1
4. Attach the A-frame to the blade and angle frame
according to the diagram below. The A-frame
cross member should be parallel to the blade.
5. With the snowplow in normal operating position,
lower the jack leg to support the headgear.
Release the jack lock to hold the jack in position.
6. Remove the protective packaging from the angle
rams.
1-1/4" x 6-7/8"
Pivot Pin
1/4" x 2"
Cotter Pin
A-Frame
Angle
Frame
Headgear not shown.
7. Align the angle ram rods with the angle ram holes
on the blade. Attach with two clevis pins, installed
from the top. Secure with 1/4" x 2" cotter pins.
8. Install the blade guides.
Jack Handle
Jack
Jack Lock
To Next Page
Loading...
