Fisher Studio Standard MT-6330 - INTRODUCTION AND SETUP; Linear Drive Technology; Unpacking The Unit; Assembling The Turntable

INTRODUCTION: "Linear Drive", a novel engineering approach to the difficult task of rotating a
turntable accurately and without undesirable drift is featured in this unit. This drive employs 120 magnetic
poles instead of the usual 4 to 24. It achieves a completely uniform rotation and virtually eliminates wow
and flutter as well as rumble.
IMPORTANT . .. This highly sophisticated turntable was developed by FISHER to give you many
years of listening enjoyment.
Please read the following instructions carefully. They were prepared to assist you during the initial set-up
and to ensure ultimate performance of the turntable at all times.
THE WARRANTY ON THIS UNIT DOES NOT COVER DAMAGE CAUSED BY MISHANDLING OR MISUSE.
WARNING: To avoid the hazard of fire or electrical shock, do not expose this turntable to rain or other
moisture.
UNPACKING THE UNIT
1 Carefully unpack the unit, the 45 rpm adapter
which is packed separately in a plastic bag, the
counterweight and cartridge shell which are
packed in padding and the rubber mat and trim
ring plate which are packed separately in plastic
bags.
Remove the three screws that hold the turntable
platter in place during shipment. (Fig. 1)
It is advisable to retain the carton, padding and
the turntable platter shipping screws in case
reshipment is necessary.
TURNTABLE PLATTER SHIPPING SCREWS STRING
Fig. 1
ASSEMBLING
Place the rubber mat and the trim ring plate onto
the turntable platter.
Rotate the cartridge shell ring of the tone arm and
attach the cartridge shell.
Screw the counterweight onto the end of the tone
arm to mount. (Fig. 2)
4 Unfasten the string or "twist tab" wire that
secures the tone arm during shipment. (Fig. 1)
Remove the stylus cover.
3