Why is there distortion in the mic channel of my Fishman Amplifier?
If you're experiencing distortion in the mic channel of your Fishman Amplifier, it might be due to a low battery. Try plugging into the stereo in jack and pushing in the battery low switch. If the LED lights up, replace the battery.
How to resolve noise caused by unshielded cable in Fishman Amplifier?
To avoid issues with your Fishman Amplifier, use only quality fully shielded instrument cables.
Why does my Fishman Amplifier hum under AC power?
If your Fishman Amplifier hums when using AC power, it might be due to an unregulated power supply. Use only Fishman 910-R or Roland PSA series AC adapters.
What to do if Fishman Amplifier has hum piezo high frequency loss?
If you are experiencing hum or piezo high frequency loss with your Fishman Amplifier, turn the phantom power on by setting the switch to the out position.
What to do if Fishman Amplifier distorted mic signal with active pickup?
If you're getting a distorted or no mic signal with an active pickup (battery on instrument) when using your Fishman Amplifier, install a Fishman Smart Switch or use separate cables for the mic and pickup.
How to fix mechanical noise from instrument cable on Fishman Amplifier?
If you're experiencing mechanical noise from the instrument cable with your Fishman Amplifier, tighten all plug hardware.
What to do if mic is dead and pickup appears in microphone channel on Fishman Amplifier?
If the mic is dead and the pickup appears in the microphone channel of your Fishman Amplifier, set the mute switch to the out position.
How to isolate mechanical noise from instrument on Fishman Amplifier?
If you're hearing mechanical noise from the instrument when using your Fishman Amplifier, listen to the instrument acoustically to isolate the noise.
What to do if no signal when using aux/mic in jack only with battery power on Fishman Amplifier?
If you're experiencing no signal when using the aux/mic in jack only with battery power on your Fishman Amplifier, insert a 1/4” plug or unused instrument cable into the stereo in jack.
General| Channels | 2 |
|---|---|
| Power Output | 100W |
| Outputs | XLR DI Out, 1/4 inch Line Out |
| Effects | Reverb, Chorus |
| Power Source | Battery or AC adapter |
Combines natural ambience with clear piezo signal for enhanced tone and projection.
Connects passive piezo pickup and mic to a stereo endpin jack.
Step-by-step guide to get the BLENDER up and running quickly.
Precautions and guidelines for using the unit with battery power.
Guide to aligning acoustic and electronic phase relationships for optimal sound.
Adjusts the volume level for the Transducer Channel.
Sets channel sensitivity for optimal signal strength and calibration.
Silences all main outputs for silent instrument changes.
Controls the overall master volume for most outputs.
Routes mic and pickup via stereo cable to STEREO IN.
To Next Page