Ellipse Blend
™
User’s Guide
User’s Guide
Ellipse Blend
Ellipse Blend
Mic Trim
VolumeBlend
Mic Trim
Phase
Microphone Positioning - Continued
Plug in the guitar and move the blend slider to the left for mic only. Start with the mic
capsule so that it faces the back of the guitar. Move the mic closer to the sound hole
for more bass. Turn the capsule toward the sides of the instrument for less bass.
Microphone Trim Control
A small circular potentiometer is recessed below the volume slider and can be
accessed with a small slotted screwdriver. This is a "set it and forget it" control. Use
it to calibrate the microphone balance in relation to the pickup. Set the Blend slider
to the center position and adjust the trim control until both the microphone and pickup
levels are balanced to your liking.
ELECTRICAL SPECIFICATIONS
:
Typical current consumption @ 9Vdc: 2 mA
Typical 9V alkaline battery life: 250 hrs.
Piezo channel input impedance (ohm): 100k
Output impedance (ohm): 1k
Recommended load impedance (ohm): 10k and up
Piezo channel signal gain (blend at piezo, volume at maximum): +3 dB
Piezo channel noise (A-weighted, 22-22kHz, blend at piezo): -106 dBV
Microphone channel signal gain range
(volume at maximum, blend at mic) 0dB to +10dB
Microphone channel low frequency roll off -3dB at 340Hz
Microphone channel noise (A-weighted, 22-22kHz, blend at mic) -103 dBV
All specifications subject to change without notice
www.fishman.com
513-000-009 • Rev A • 4-16-04
To Next Page
Need help?
General
