Fishman SWITCHJACK User Manual

1
www.fishman.com
Installation of this product is a simple procedure, but we recommend this job only if you are an experienced
repair technician.
The Switchjack is an easy to install TRS stereo jack with an additional “4th pin” terminal for battery switching
(figure 1). It is manufactured exclusively for Fishman by Switchcraft Inc.
The switch terminal on the Switchjack is typically connected to the negative battery wire of an active pickup
system. When you insert a plug, the negative battery wire connects to ground via the sleeve, and the system
switches on.
Preliminary
To gain better access to the Tip, Ring and Switch terminals, gently bend back the Strain Relief/Sleeve tab before
soldering (figure 2).
INSTALLATION GUIDE
Installation
1. Remove the endpin and enlarge the hole to
15
∕
32
".
2. Follow this sequence when you install the endpin jack (figure 3):
1. Large backing nut
2. Large backing washer
3. Star washer
4. Guitar endblock
5. Small dress washer
6. Small dress nut
7. Strap nut
Figure 2. Bend back strain relief
Figure 1. Tip, ring, sleeve and switch terminals
Figure 3. Installation sequence

Fishman SWITCHJACK Specifications

General

Brand	Fishman
Model	SWITCHJACK
Category	Music Equipment
Language	English

Summary

Preliminary

Installation

Endpin and Hole Preparation

Remove the endpin and enlarge the hole to 15/32 inch before installing the jack.

Endpin Jack Installation Sequence

Follow the specific sequence of components for installing the endpin jack.

Wiring Options

Passive Pickup Wiring

Diagram showing wiring for a single passive pickup to the Switchjack.

Active Pickup Wiring

Diagram showing wiring for an active pickup system with battery switching.

Stereo Passive Pickup Wiring

Diagram for connecting two passive pickups in stereo.

Active and Passive Stereo Wiring

Diagram for connecting active and passive pickups in stereo.

Passive Pickup and Mini-Mic Wiring

Diagram for connecting a passive pickup and mini-mic.

Active Pickup and Mini-Mic Wiring

Diagram for connecting an active pickup and mini-mic.