5
Disconnect Chassis from Cabinet
1. Remove fi ve connectors from Chassis PCB at board locations JP5, JP6, JP8, JP9 and JP10.
2. JP5 and JP6 require thumb pressure to release clip as shown. JP8, JP9 and JP10 all pull straight out.
3. Pull green and yellow ground wire through cabinet as shown. The Power Amplifi er Chassis is now
disconnected and can be completely removed from the cabinet. Put replaced chassis aside.
LOUDBOX 100 POWER AMPLIFIER
CHASSIS REPLACEMENT
JP5
JP6
JP8
JP9
JP10
JP5
JP6
JP8
JP9
JP10
JP5: blue/yellow/red/black
JP6: blue/gray/blue
JP8: alternating black/red
JP9: brown/white/blue
JP10: red/brown/orange/white/black
To Next Page
Loading...
