Need help?Do you have a question about the Fishman PRO-EQ PLATINUM BASS and is the answer not in the manual?
Nominal Input and Output| nominal input level | -14 dBu |
|---|---|
| input overload level | +10 dBu |
| input impedance | 10 MΩ |
Nominal Output Levels and Impedances| amp out level | -20 dBu to +10 dBu (1 kΩ) |
|---|---|
| tuner/send out level | -14 dBu to +10 dBu (1 kΩ) |
| XLR out level | -30 dBu to -6 dBu (600 Ω) |
Tone Controls| bass control | ±12 dB @ 30 Hz |
|---|---|
| low mid control | +6 dB, -12 dB @ 200 Hz |
| mid control | +6 dB, -12 dB @ 1.25 kHz |
| hi mid control | ±9 dB @ 5 kHz |
| treble control | ±12 dB @ 10 kHz |
Depth Control| depth control filter | 12 dB / octave low cut filter |
|---|---|
| depth control range | 15 Hz (5:00) to 125 Hz (7:00) |
| compressor max gain reduction | -14 dB |
Power| battery type | 9 Volt Alkaline Battery |
|---|---|
| battery life | est. 80+ hours continuous |
| current draw | 4.5 mA typical |
| phantom power | 48 Volt phantom power via XLR cable |
| AC adapter | Fishman 910 or Boss PSA series (center negative) |
Explains how to install and use a 9V battery for power.
Details using phantom power from a mixer for operation.
Specifies requirements for using a compatible AC adapter.
Explains the LED flash indicating the unit is powering up.
Details the LED flash when the bass signal overloads the preamp.
Explains the LED warning for low battery life.
Adjusts deep bass frequencies and mid-bass punch for D and G strings.
Outputs a 'dialed-in' sound through the PA for live mixing.
Provides a 'flat' DI signal for recording or sound engineer control.
Configures the XLR output for personal sound via the PA.
Connect to a bass amp with flat tone controls for primary EQ.
Bypass amp preamp for cleaner sound via effects return.
Bypasses controls for a true DI to PA and bass amp.
To Next Page