Need help?Do you have a question about the Fishman V-200 and is the answer not in the manual?
General| Mounting | Bridge-mounted |
|---|---|
| Impedance | High impedance |
| Type | Piezoelectric pickup |
| Output | 1/4" jack |
| Battery | None required |
| Battery Life | Not applicable |
Describes the V-200 as a piezoelectric violin transducer, detailing its design and features.
Advises careful handling of the high-performance transducer, especially during installation.
Instructions to remove rosin deposits and inspect bridge wing slots for proper fit before installation.
Details on measuring the wing slot, fitting the transducer, and ensuring correct contact with the bridge.
Guidance on locating and tightening the pickup jack to the violin using the chinrest key.
Method for adjusting the pickup's position for the best sound quality through trial and error.
Advice on cable type and input connection to affect sound quality for passive pickups.
Recommendations for using high-quality, low-capacitance shielded cables for optimal tone and minimal hum.
Considerations for connecting to various audio inputs due to impedance standardization differences.
Strongly recommends using impedance-matching, buffered preamps for full frequency response and compatibility.
Guidance on using musical instrument amplifiers, noting ideal impedance matching for piezo pickups.
Advice on connecting to active direct boxes for good results, cautioning against passive ones.
Explains the need for an impedance matching preamp when connecting to PA or recording consoles.
Details the one-year limited warranty, exclusions, and conditions for repairs or replacements.
Outlines the step-by-step process for returning products for warranty service or assessment.
To Next Page
