Reference 20FEB2018 Pg 16 of 16 Copyright 2018 Fishmaster
APPENDIX A - Wiring Instructions for your Fishmaster T-Top
If you add speakers, lights, antenna or other items to your Fishmaster T-Top, you can hide the wires
inside of the tubing of the T-Top. When wiring and you get to the hinge’s drill a hole 1 inch above the weld
on the top section and drill a hole 1” below the weld on the bottom section. Loop the wire out of the tubing
of one section and back into the tubing in the other section. Leave 5 – 6 inches of wire out in order for the
t-top to fold. The hole size will depend on what size wire and connector you are running and how many
items you need to wire. The maximum hole size we recommend is ½” but normally smaller is all that is
needed.
ADDITIONAL RESOURCES OF INTEREST
The various connectors, finishing grommets and items you will need for wiring lights and speakers can be
found at Radio Shack, Home Depot, Lowe’s, Ace and other hardware stores. You can also find much of
this at www.WayTekWire.com as well as many other online sources. There are some great technical
documents at www.installdr.com that may be of assistance as well. If you are interested in making your
own speakers or other items for your T-Top, check out www.diyTower.com.
To Previous Page
Loading...
