Need help?Do you have a question about the Fiskars 100770-1001 and is the answer not in the manual?
Lists the main components of the Fuse Creativity Machine.
Describes the integrated storage feature of the machine.
Highlights the user-friendly crank mechanism.
Identifies the portability feature of the machine.
Details the design set including die and letterpress plates.
Specifies a crucial cutting plate with an attached rubber mat.
Identifies the base plate used in the system.
Specifies the ink pad accessory for letterpress.
Step-by-step instructions for opening the machine for use.
Instructions to take out starter set components from storage.
Illustrates the layer configuration for die-cut and letterpress.
Illustrates the layer configuration for die-cut and press only.
Illustrates the layer configuration for die-cut only.
Illustrates the layer configuration for letterpress only.
Illustrates the layer configuration for press only.
Guidance on selecting and placing the correct die and plate.
Instructions for correctly positioning the die within the machine cover.
Steps for applying ink to the letterpress plate.
Instructions on preparing the inked die for the machine rollers.
Guidance on selecting and placing the correct die and plate.
Instructions for layering materials to create the sandwich.
Guidance on feeding the sandwich through the machine rollers.
Instructions on how to remove the finished product.
Instructions for selecting a die without a letterpress plate.
Instructions for layering materials to create the sandwich.
Guidance on feeding the sandwich through the machine rollers.
Instructions on how to remove the finished product.
Steps for selecting and inking the letterpress plate.
Instructions for layering materials to create the sandwich.
Guidance on feeding the sandwich through the machine rollers.
Instructions on how to remove the finished product.
Instructions for placing the letterpress plate on the base plate.
Instructions for layering materials to create the sandwich.
Guidance on feeding the sandwich through the machine rollers.
Instructions on how to remove the finished product.
Overview of the standard steel-rule design set.
Introduction to expansion packs for added creativity.
Details on available design set styles: photo-etched and steel-rule.
Information on photo-etched dies and their cutting materials.
Information on steel-rule dies and their cutting materials.
Details how expansion pack plates fit into design set dies.
Information on the adapter kit for using competitor dies.
To Next Page
General