To Next PageTo Next Page
Need help?Do you have a question about the FitDesk 4010 and is the answer not in the manual?
General| Brand | FitDesk |
|---|---|
| Model | 4010 |
| Category | Exercise Bike |
| Language | English |
Read and follow all warnings and precautions for safe assembly and use of the equipment.
Attach front and rear stabilizers to the main frame using washers and cap nuts.
Attach the left pedal to the crank arm, ensuring it is tightly secured.
Attach the right pedal to the crank arm, ensuring it is tightly secured.
Mount the seat onto the seat support tube using bolts, lock washers, and nuts.
Attach the seat back post to the seat support tube using bolts and washers.
Mount the seat back cushion to the seat support tube using allen bolts and lock washers.
Insert the desktop and adjustment bar into the main frame and tighten the knob.
Slide meter holder and wire through desk, install screws, then attach meter and plug wire.
Read and understand all warning stickers on the FitDesk before operation.
Turn the resistance knob clockwise to increase load, counter-clockwise to decrease.
Adjust desk tilt, forward/backward slide, and height using specific knobs.
Adjust the seat tilt to three positions by pulling and repositioning the pin knob.
Explains how to use the Mode, Reset, and Set buttons for time, speed, distance, and calories.
Verify all bolts are present and tightened; inspect nuts, screws, and knobs weekly.
