FiTech Go EFI Classic 30020 - User Manual

Please read the full instructions before beginning your installation.
These instructions cover the basic kit installation and setup. Failure
to follow these instructions may result in malfunctioning of the
system. For technical assistance with your Go EFI Classic System,
call the FiTech EFI Tech Line at (951)340-2624
Warning: Caution must be observed when installing any product
involving fuel system parts. Work in a well ventilated area with an
approved fire extinguisher readily available. Eye protection and
other safety apparel should be worn to protect against debris and
sprayed gasoline. We recommend having this installation per-
formed by an experienced, qualified, automotive technician. The
finished installation must be thoroughly checked for any fuel sys-
tem leaks. All safety precautions must be observed when working
with fuel. Disconnect the battery ground wire (-) before starting
the installation.
Kit contents 1
About your Go EFI Classic System
2
Special instructions 2
Engine protection feature 2
Vacuum Ports 2, 3
Throttle Body Installation 3
Wide Band O2 Sensor Installation 3
Air Leaks 4
Installing the Harness 4
4
4
4
4, 5
5
5
5
5, 6
MAP
IAC
TPS
Coolant Sensor Installation
Injectors
Wiring the EFI System
On-Engine Adjustments
IAC setup
Wire Chart 6
Handheld Controller 6
Initial Programming 6
Fan Setup
6
Fuel Delivery Requirements 7
Wiring Diagrams
With Ready-to-Run distributor 8
9
With HEI distributor
With External CDI Box
10
Table of Contents
1
Go EFI Classic 30020
KIT CONTENTS
(1) 4-injector throttle body with Classic
Carburetor Gold finish.
(4) inlet/outlet port plugs (Installed on throttle
body)
(1) Harness “A” (plug-in pigtail use harness)
(1) Cable for handheld controller
(1) ECU
(1) Coolant Temperature Sensor
(1) 1/2" NPT to 3/8" NPT Reducer
(4) Injectors pre-installed
(1) Idle Air Control (Pre-Installed)
(1) Throttle Position Sensor (Pre-Installed)
(1) MAP Sensor (Pre-Installed)
(1) Wide Band O
2
Sensor
(1) Clamp on O
2
Bung Kit
(1) Handheld Controller with billet case
(1) Windsheild Mount for Controller
(1) -06 AN crossover hose with -6AN male
inlet fitting (Pre-Installed)
(1) Gasket kit
Figure 1
Instruction Manual
for the following Go EFI
System
30020 - Go EFI CLASSIC
Note:
These kits are not
legal for use on pollu-
tion controlled vehicles
A
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

FiTech Go EFI Classic 30020 Specifications