Note: You may refer to our installation videos for step by step instructions as well.
Step 1: Laying the bottom of swimming pool
Find an approximate 8.5ft x 11.5ft space on the ground. Remember to
give yourself enough room to walk around the perimeter comfortably.
Place and stretch out the mattress pad on the ground. For iPool heater
owners, it is recommended to get some foam or rubber padding to
place below the pool to provide insulation and prevent heat from
seeping out from bottom of the pool.
Step 2: Liner placement
Place the liner on the just-placed ground tarp and stretch out outside. Remember to fully extend the
liner sleeves to ensure you have sucient room for the leg supports.
Note: To make it easier to install, it is recommended to place the open liner under direct sunlight to
dry for about 2 hours.
THE IPOOL INSTRUCTION MANUAL
Pool Set-Up
Please carefully read this instruction manual
before installing and using the iPool
11
To Next Page
Loading...