Note: You can refer to our installation videos for step by step instructions as well.
Step 1: Preparing space for your iPool and laying the mattress pad
Step 2: Liner placement
Place the liner (#35) on the just-placed ground tarp, and stretch it out fully. Remember to extend the liner sleeves fully to
ensure you have sucient room for the leg supports.
Note: To make it easier to install, place the open liner in direct sunlight for about 2 hours. to dry it and make it more supple.
THE IPOOL INSTRUCTION MANUAL
Pool Set-Up
Please carefuy read is instruction manual
before instaing and using e iPl
11
Find or create a cleared 9 ft x 12 ft space on level ground. Give yourself enough
room to walk around the perimeter comfortably. Place and stretch out the mattress
pad (#36) in that space.
For iPool heater owners, we recommend placing foam or rubber padding below
the mattress pad to provide insulation, which helps prevent heat from seeping out
from the bottom of your iPool. Home improvement stores typically stock large
rubber mats, approximately 1/2 inch thick, and 3 ft x 4 ft in diameter. To create a
comfortable insulated pad for your iPool, arrange 9 of them in a 3 x 3 grid on a
cleared 9 ft x 12 ft piece of ground, and then lay the mattress pad on top of it.
To Next Page
Loading...
