FIVE OCEANS PACIFIC WINDLASS Series - 4- Installation; 4.1 Basic requirements

7
FIVE OCEANS PACIFIC SERIES
3.2 Fitting
• This equipment must be installed and operated in accordance with the instrucons con-
tained in this manual. Failure to do so could result in poor product performance, personal
injury and/or damage to your boat.
• Consult the boat manufacturer if you have any doubt about the strength or suitability of
the mounng locaon.
3.3 Electrical
• Make sure you have switched o the power before you start installing this product.
• This product requires installaon by a suitably qualied electrical engineer.
4- Installation
4.1 Basic requirements
Each installaon requires the following tools: Windlass Installaon
WIRING INSTALLATION
• Crimping Pliers / Wire Stripper
• Suitable electrical cable and crimp
terminals
Pacic 600
5/16"
5/16"
5/16"
5/16"
Pacic 900
Pacic 1000
Pacic 1500
MODEL
DRILL
in
mm
8
8
8
8
1 11/16"
1 11/16"
2 9/16"
2 9/16"
2 3/32"
2 3/32"
2 3/32"
2 13/32"
44
44
52
61
in
mm
HOLE SAW SM
in
mm
HOLE SAW LG
52
52
65
65
DRILL HOLE
HOLE SAW SM
HOLE SAW LG