Receiver switching on / off:
To switch on the receiver:
■ Press the ON / OFF button for approx. 1 sec.
■ A double short beep will sounds, and LEDs ash briey towards the right; LED BAT
indicates the battery charge (green LED = battery OK).
To switch off the receiver:
■ Press the ON / OFF button for approx. 1 sec.
■ A long-drawn deep beep will resound, and LEDs ash briey towards the left.
Pairing with the bite alarm (or other accessories):
■ Press and hold the PLUS and MINUS buttons together for 1 second.
■ A white LED comes on at position 1.
■ Use the PLUS and MINUS buttons to move to the position where you want to save the
new device. Rotate the roller of the bite alarm, which sends a signal and the receiver to
save it. Pairing is completed.
If a deep beep sounds at pairing, and the white LED is still on (the bite alarm has not been
paired), the position is already occupied, or the same bite alarm has already been saved
in the memory. In the same way, you can also pair other accessories (alarm devices). You
have up to 12 channels available, two devices for each LED. The rst group of six lights
with white LED while learning, the other group of six lights with red LED.
Removal of bite alarm from the memory:
■ Press the PLUS and MINUS side push buttons together.
■ A white LED comes on at position 1.
■ Use the PLUS and MINUS buttons to move to the position you want to delete (release).
■ Press the MINUS push button and hold for 1 second. = deleted.
■ The deletion is indicated by a quite deep beep and the red LED at a given position (1 – 6).
Differentiation of parachute at receiver:
Flashing LED = parachute indication.
Remote control of FLACARP lights:
The receiver allows you to control FLACARP lights remotely. Simply by short pressing
the main push button on the receiver, you can control up to four FLACARP lights. Press
this main push-button once, you control the rst light; when you press the push-button
twice, you control the second light; when you press the push-button three times, you
control the third light; when you press the push-button four times, you control the
fourth FLACARP light. The transmitting, or the chosen channel is displayed by short
lighting-up of LED No. 1–4 on the receiver.
Clear adjustment of sound volume:
When adjusting the volume using PLUS and MINUS side push buttons, the volume level
is now clearly displayed by a LED column on the receiver (1-6).
Range of receiver, battery life:
Our bite alarms are equipped with a high-powered transmitter for a long range. The reason
for this super-sized range consists in its excellent spreading even in the case of obstacles,
dams, and terrain irregularities, which reduce the range signicantly. Our receiver will be thus
reliable even in places where other bite alarms can fail. The battery lifetime corresponds to
the frequency of product use and to the intensity of sound indication; at bite indicator, it also
depends on the adjusted LED brightness and beep volume. The higher LED brightness or
the more intensive beep, the shorter battery lifetime. If you do not use the bite indicator for a
longer period of time (at the end of the season), we recommend to remove the batteries to
avoid product damage caused by leaking batteries.
4
+420 731 115 151 | flacarp@tfe.cz | www.flacarp.com
RECEIVER - DESCRIPTION OF FUNCTIONS
To Next Page
Loading...