Flair NEO Flex - Neo Flex Brewing Preparation; Neo Flex Brewing Instructions

Preparing your NEO Flex for Brewing
Brewing with Your NEO Flex
Preheat the
Brew Cylinder
Boil water. Add preheat
cap to bottom of brew
cylinder. Fill with boiled
water. Leave for at least
30 seconds. Repeat as
needed.
Start with the Flow-
Control Portalter
When ready to brew
with the Bottomless
portalter (black), an
espresso capable burr
grinder, and dialing-in, is
required.
Prepare your Freshly
Roasted Beans
Start with 15 grams
of beans or grounds
(roughly 3 tablespoons).
If grinding, do so right
before brewing for the
best results.
Separate Your
Brew Head
Separate the brew
head into four parts: 1)
Piston 2) Brew Cylinder
3) Screen 4) Portalter.
Tip: Use dosing cup to
remove piston.
(a) Ax funnel to selected portalter and ll with
grounds. Tap lled portalter on level surface to
settle grounds. (b) Tamp lightly. (c) Remove funnel
and place portalter on post and add screen.
(a) (b) (c)
(a) Empty preheat water, remove preheat cap and
add cylinder to portalter. (b) Add brew water (198-
208˚F, 92-97˚C) to cylinder. Fill to line.
(a) (b)
(a) Add piston to top of cylinder. (b) Slowly press the
lever down until you see a steady stream. Maintain
this amount of force until the lever is lowered. If you
cannot lower the lever, you have ground too ne.
(a) (b)
1)
2)
3)
4)
*WARNING!
Never Release
Lever Abruptly!
Boiling water
may SPRAY!