Need help?Do you have a question about the flakt woods TopMaster and is the answer not in the manual?
General| Casing | Double skin casing with thermal break |
|---|---|
| Filtration | G4, F7, F9 |
| Construction | Modular construction |
| Insulation | Mineral wool |
| Coil Options | Water coils, DX coils |
Details the electrical cabinet components and their arrangement.
Explains electrical connection points and fuse protection for the unit.
Explains how sensors and accessories are connected to the electrical cabinet.
Illustrates cable securing and lead-through sealing in the electrical cabinet.
Details the factory-mounted temperature sensors (Supply, Outdoor, Extract).
Covers room sensor, freeze protection, filter monitors, air flow monitors, damper, and timers.
Describes the rotor pressure switch for defrosting.
Details connections for water heating and liquid cooling pumps/actuators.
Mentions electric heater connection and DX-cooling electrical setup.
Describes external fire alarm connection and total alarm output.
Details connection and stroke length for valve actuators.
Explains operation and installation of VXG and VVG valves.
Provides a diagram and list of external component connections.
Step-by-step guide for installing the touch control panel.
Notes that the control panel is intended for indoor use only.
Introduces the touch control panel and navigation methods.
Provides instructions on how to clean the touch screen safely.
Explains common buttons and symbols used on menu pages.
Describes the elements in the status line of the home screen.
Explains alarm indicators and lists operating status indicators.
Details the different operating modes (Trickle, Normal, Boost).
Shows how to quickly adjust the temperature set point.
Shows how to quickly adjust the time and date.
Refers to page 13 for selecting operating modes.
Explains how to change operating modes via the home screen.
Details alarm symbols, screens, and resetting alarms.
Describes setpoint configuration, fan control, system overview.
Guides the user to enter the main settings menu.
Step-by-step instructions for setting time, date, and language.
Explains the login process for accessing advanced settings.
Lists various settings accessible to installers and service personnel.
Explains how to configure fan settings using the wizard.
Details two ways to change fan speeds (buttons or keypad).
Introduces schedule types and explains priority rules.
Details programming weekly schedules for fan operation.
Provides an example of a weekly schedule configuration.
Shows a weekly schedule example with varying times and days.
Shows a weekly schedule example with trickle speed and temperature adjustments.
Explains one-off schedules for a single date.
Explains one-off schedules for a specific date range.
Explains unit configuration for heating, heat recovery, and cooling.
Explains how the unit achieves setpoints using dead zones.
Details supply air control and extract air control methods.
Covers supply air, extract air, and room control modes.
Explains temperature control for a single room using a room sensor.
Describes adjusting supply air setpoint based on outdoor temperature.
Warns about freeze protection parameters and potential water damage.
Explains the defrost function to prevent rotor freezing.
Explains cooling energy recovery based on temperatures.
Details how night cooling reduces load during summer nights.
Introduces pressure control (COP) and flow control (CAV).
Details pressure sensor connections and zero point-calibration.
Lists parameters, types, ranges, default values, and comments.
Covers parameters for temperature status and fan status.
Lists settings for Time/Date, Language, and Login.
Lists parameters for timer functions, fan speed, and control modes.
Details parameters for pressure and flow control.
Lists parameters for night cooling, modes, and freeze protection.
Covers general alarm handling and specific alarm category parameters.
Lists parameters for various alarm delays.
Covers contact functions for timer inputs and sensor inputs.
Covers IP address, menu settings, Modbus, and password management.
Explains saving/uploading values, SD card use, and logging out.
To Next Page