FlaktWoods FICO FCLA-128 - User Manual

Cotrol system FICO-128
Installation, use and maintenance
09/2014

Summary

1 Connection instructions, system with individual indication

4 Control unit FCLA-128

5 Communication unit FCBA-2 and relay unit FCFA-1

Relay unit FCFA-1

6 Installing communication unit FCBA-2

7 Installing control unit FCLA-128

8 Taking FCLA-128 with its FCBA-2 communication units into use

Initial System Login and Access

Steps for powering on, logging into the system, and initial user access.

Activating Units and Starting System Operation

Guides through activating communication units and initiating system operation.

Setting Up the Damper Test Schedule

Sets the time and frequency for automatic damper tests.

9 Settings

Logging into the Control System

Instructions for accessing the system menu by logging in with a code.

Setting System to Standby Mode

Procedure to put the system into Standby mode before configuration changes.

12 Manual test of dampers, communication units, and groups

13 Shutting off a communication unit to allow maintenance of damper without activating alarm

Service Mode for Unit Maintenance

Procedure to temporarily disable a communication unit for safe maintenance.

14 Adding a communication unit to the system

Connecting and Addressing New Communication Unit

Steps for physically connecting and assigning an address to a new communication unit.

15 Adding a relay unit to the system

Connecting and Addressing New Relay Unit

Steps for connecting and assigning an address to a new relay unit.

16 Connecting damper motor; smoke detector to a communication unit with only one damper motor; smoke detector connected to it

Connecting Single Device to Unit

Detailed steps for connecting one damper motor or smoke detector to a communication unit.

17 Disconnecting damper motor; smoke detector from a communication unit with two damper motors; smoke detectors connected to it

Disconnecting Single Device from Unit

Steps for safely disconnecting one damper motor or smoke detector from a unit.

18 Disconnecting communication unit; relay unit from the system

Removing Unit from System Configuration

19 Alarms at control unit FCLA-128

20 Alarms at communication unit FCBA-2

22 Systems with battery in equipment where afterblow is required before fan is stopped

Setting Damper Delay (Afterblow) Time

23 Resetting control unit FCLA-128 to factory settings

Performing FCLA-128 Factory Reset

Steps to restore the FCLA-128 control unit to its original factory settings.

FlaktWoods FICO FCLA-128 Specifications