Flama 4961FL - Operation; Cleaning and Maintenance

11
English
DESCRIPTION
1. Handle lock
2. Handle
3. Grill plate with non-sck coang
4. On/o indicator lights
5. Plate locking buon
6. Power cord winder
OPERATION
Before the rst use
Remove all the labels, sckers and tags,
except the plate of product characteriscs.
Clean the appliance as described in the
Cleaning and Maintenance secon.
Use
CAUTION: Do not use this appliance to
cook or defrost frozen food. All foods must
be completely thawed before cooking them
with this appliance.
NOTE - during the rst minutes of operaon
(only upon rst use), the appliance may
release some smoke and odours, which
soon disappear.
Completely unwind the power cord.
Place the appliance on a at horizontal
surface, ensuring that the power cord is not
stretched.
Use the plate locking device to lock and/or
unlock the plates.
Lightly brush the surface of the plates
with cooking oil. Close the appliance and
connect it to the plug.
Connect the power cord plug to the power
socket. If using an extension, make sure
that it is earthed and suitable for 6A. The
on/o indicator light should switch on,
indicang that the appliance is connected
to the power socket and heang up.
WARNING: The non-sck plates and
surfaces of the appliance may heat up
during its operaon. To prevent risk of
burning, only touch the appliance using the
handle.
Allow the non-sck plates to preheat; the
on/o indicator light switches o.
Use the handle to raise the upper plate.
Place the food on the lower plate, if
necessary, using a heat resistant wooden or
plasc utensil.
CAUTION: Do not use metal utensils on the
non-sck plates, as they could damage the
non-sck coang irreparably.
Lower the upper plate using the handle.
While the appliance is being used, the
on/o indicator light switches o and on,
which is normal, indicang that the cooking
temperature is maintained.
To release the non-sck plates, slide the
locking buon. To reinsert the plates, slot
the plates into the rear xtures and press
next to the locking buons unl the plates
are xed.
CLEANING AND MAINTENANCE
Turn o the appliance by removing the
power cord plug from the power socket and
allow it to cool.
When it is completely cold:
Remove the plates and wash them by
hand with hot water and a non-abrasive
detergent. Do not use abrasive utensils or
sponges, so as not to damage the non-sck
coang. If necessary, leave the plates to
soak for a few hours. Wash and clean with
a so and dry cloth. Do not place the plates
in the washing-up machine.