Electrical Connection Instructions
Aer the switch is mounted, the electrical cables can be
attached to the switch.
Caution: Disconnect the negative battery cable from the bat-
tery before connecting any cables to the switch. e switch
will operate eectively by installing it in either the negative or
the positive system.
1) Select the cable into
which the switch will be
installed. Disconnect both
ends of this cable from its
attachment points.
2) It may be necessary
to discard this cable and
replace it with 2 separate
cables. e length of these
cables will equal the length
to the switch as shown.
3) Attach the two cable
ends to the terminal studs
as shown in the illustration.
Tighten the hex nuts until
the lock washers atten
(7-10 , lbs.). Do Not Over
Tighten! Make sure the
cables on the switch are not
touching.
4) Connect the other two
ends of the cables to their connection points. Reconnect the
battery.
Flaming River Industries, Inc.
800 Poertner Dr. Berea, Ohio 44017
1-800-648-8022 • www.amingriver.com
FR1003 011111
To Previous Page
Loading...