www.flash-butrym.pl Strona 4
every four years.
The installation fixture must be as such that it can withstand for a period of 60 minutes 10 times the load capacity
without harmful deformation.
It is prohibited for any individual to unnecessarily stay or pass beneath the installation during any type of assembly
work.
The light effect unit must be secured by a safety arrester cable if fly-mounted. The cable must withstand 12 times the
weigh of the light effect unit Use arrester cables equipped with quick closing links. The dropping distance must not
exceed 20 cm. Defect arrester cables or arrester cables that have already been exposed to stress must not be used.
6. Operation
Controls
Link all DMX devices with a DMX-512 controller by using a standard,3-pin DMX cable. Connect the output of the first
device with the input of the second device and the output of the second device with the input of the third device and
so on.
Connect the mains plug to an outlet.
Operating the product for the first time may generate smoke and odour, this is not a defect. Avoid disconnecting the
product repeatedly and quickly from/with mains! Always wait 15 minutes prior to the next disconnection!
The device starts not until a self-testing and starting time. If the moving head is ready to start, push and roll the
function wheel. The LCD display shows the options, as below:
7. Lamps
During operation, the lamps will reach temperatures of up to 600
O
C.Touching the lamps may cause serious burns!
Objects coming into contact with the lamps during and shortly after operation may catch fire!
Disconnect the product from mains prior to installing or before changing a lamp! Allow a lamp to cool for
approx.15minutes before exchanging it!
Never touch a lamp with bare hands! If damaged or deformed, a lamp must be exchanged!
When exchanging the lamp be sure to use suitable lamps only. Lamps with greater performance generate excessive
heat for the product; risk of fire! Damage resulting from the use of an unsuitable lamp is exempt from warranty!
Never connect the lighting effect to the mains prior with opened housing.
8. Fuse
Disconnect the product from the mains prior before changing a fuse.
Only replace the fuse by a fuse of same type and rating! An incorrect fuse could damage of destruct the lighting effect.
Replace a fuse by levering the fuse holder cover with an appropriate screwdriver. Remove the old fuse and place the
fuse inside the holder. Replace the fuse holder and insert it.
Never connect the lighting effect to the mains prior with opened housing.
To Next Page
Loading...