Flash LED Spyder Mini - Introduction; Safety Information; Product Information; Specification

www.flash-butrym.pl
2
1 INTRODUCTION
Thank you for purchasing LED Spyder Mini 8x3W 4in1 RGBW. For safety reasons and to ensure the trouble-
free operation, carefully read the instructions.
2 SAFETY INFORMATION
1. Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2. Disconnect the power supply before installation.
3. Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4. Do not use the device in high humidity conditions and at temperatures above 40° C
5. To avoid damage please don't use organic solvents to clean the fixture shell.
6. The device must be installed on stable structures
7. It should be installed in a well-ventilated place, at a distance of 15cm or more from the walls.
Please check if the fan and ventilation holes are unobstructed.
3 PRODUCT INFORMATION
3.1 Specification
 Power consumption: 46W
 Power supply voltage: 100 - 240V
 Voltage frequency: 50/60Hz
 Diode type: Standard LED (Single color)
 Number of diodes: 8
 Diode power: 3W
 Display: LED - 4 characters
 Color: RGBW
 Beam angle (min): 4°
 Beam angle (max): 4°
 Dimming: Linear: 0 - 100%
 TILT range: 135°
 Number of DMX channels: 7 / 13
 DMX standard: DMX 512
 Control interface: 4 buttons
 Operating modes: DMX512, Auto, Sound-controlled, Master / Slave
 AC IN: IEC - C14
 AC OUT: IEC - C13
 DMX IN: XLR - 3 pin
 DMX OUT: XLR - 3 pin
 Cooling: Active
 Height [cm]: 13,5
 Width [cm]: 28
 Depth [cm]: 16
 Weight [kg]: 2,3