CARE- AND SAFETY INSTRUCTIONS:
Never open or short circuit the battery. Never expose the battery to moisture or fire. Always make sure the
Batteryis connected with the correct polarity (+/-). Always avoid short circuits which can be caused, for example
bymetalobjects.
CAUTION: ifthe Batteryismisusedthere is a danger of leaks,explosionorfire!Only use chargerswhichare suitablefor
the specific type of Battery. The lifetime of the battery is limited and can be shortened by incorrect handling. To avoid
damage to the Battery, please observe the following instructions:
1.Always avoid deep discharging ofthe Battery.
2.TostoretheBatteryforlongerperiods (e.g. inwinter),firstmakesureitis charged(at least 50%).Store Batteryin a cool
dry place.
3.Avoid exposing the Batteryto high ambient temperatures.
4.Always charge Batteries onlywith a suitable charger.
SAFETYFUNCTIONS:
1. Gentle safety charge start
Charging is started only after an automatic check of the charge status and battery condition If the check is not
successful(error), the charging process is interrupted
2. Charging time safetytimer
Automatic disconnection of the charging process after 14 hours
3. Trickle charge forregular use
The charging process only starts whenthe battery capacity is below 85%.
This function helps the batteryto keep its ideal capacity range and serves as further protection
The Charger is designed for indoor use only and should not come into contact with water, dust, heat or direct
sunlight. To prevent overheating the product should not be covered whilst in use. Keep the device away from
vibrations anddonotdropthedevice. Keepallflammable materials awayfromtheCharger. Donotusethe device
in an explosive environment. This Charger is designed for use with a lithium-iron phosphate batteries and
Lithium-polymer batteries. For safety reasons, this Charger must be used only for Lithium-ion and Lithium-
polymerBatterieswhich have 7 cells in series: Outputvoltage 25.2Vor25.9V. Donotattemptto charge Batteries
that are not expressly stated bythe manufacturerto be suitable forthe currents the Charger delivers duringthe
charge process. Do not attempt to charge faulty or damaged Batteries. The mains socket should be easily
accessible. In the event of operational error, the plug should be immediately removed from the socket. The
product contains dangerous voltages and the cover should not be removed. All service or maintenance work
should be carried out byauthorised personnel orthrough a representative ofthe manufacturer. The Charger has
internal fuse which blows if a fault occurs in the Charger. Such faults must be repaired by qualified service
personnel. The Chargeris double-insulated (insulation class II).
Productswith plastic casing should not coming intocontactwithoils, grease etc.,as mosttypesofplastic can be
broken down by chemicals and solvents. The manufacturer accepts no liability or responsibility for damages
caused by incorrect operation, failure to follow the instructions for use, failure to comply with the maintenance
instructions, incorrect maintenance or any other form of incorrect handling or misuse of the device, whether by
the buyeror bythird parties (e.g. incorrect operation,wrong connection, wilfuldamage, etc.).
EN
To Next Page
Loading...
