Flavel WFA6100W - Page 23

Washing Machine / User’s Manual
23 / EN
Problem Reason Soluton
Washing takes longer time than
specified in the manual.(*)
Water pressure is low. • Machne wats untl takng n adequate
amount of water to prevent poor washng
qualty due to the decreased amount of
water. Therefore, the washng tme extends.
Voltage might be low. • Washng tme s prolonged to avod poor
washng results when the supply voltage
s low.
Input temperature of water might be low. • Requred tme to heat up the water extends
n cold seasons. Also, washng tme can be
lengthened to avod poor washng results.
Number of rinses and/or amount of rinse water
might have increased.
• Machne ncreases the amount of rnse water
when good rnsng s needed and adds an
extra rnsng step f necessary.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent usage.
• Use recommended amount of detergent.
Programme time does not
countdown. (On models with
display) (*)
Timer may stop during water intake. • Tmer ndcator wll not countdown untl the
machne takes n adequate amount of water.
The machne wll wat untl there s suffcent
amount of water to avod poor washng
results due to lack of water. Tmer ndcator
wll resume countdown after ths.
Timer may stop during heating step. • Tmer ndcator wll not countdown untl the
machne reaches the selected temperature.
Timer may stop during spinning step. • Automatc unbalanced load detecton system
mght be actvated due to the unbalanced
dstrbuton of the laundry n the drum.
Programme time does not
countdown. (*)
There might be unbalanced load in the machine. • Automatc unbalanced load detecton system
mght be actvated due to the unbalanced
dstrbuton of the laundry n the drum.
Machine does not switch to
spinning step. (*)
There might be unbalanced load in the machine. • Automatc unbalanced load detecton system
mght be actvated due to the unbalanced
dstrbuton of the laundry n the drum.
The machine will not spin if water is not drained
completely.
• Check the flter and the dranng hose.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent usage.
• Use recommended amount of detergent.
Washing performance is poor:
Laundry turns gray. (**)
Insufficient amount of detergent has been used
over a long period of time.
• Use the recommended amount of detergent
approprate for water hardness and the
laundry.
Washing was made at low temperatures for a
long time.
• Select the proper temperature for the
laundry to be washed.
Insufficient amount of detergent is used with
hard water.
• Usng nsuffcent amount of detergent wth
hard water causes the sol to stck on the
cloth and ths turns the cloth nto gray n
tme. It s dffcult to elmnate grayng once
t happens. Use the recommended amount
of detergent approprate for water hardness
and the laundry.
Too much detergent is used. • Use the recommended amount of detergent
approprate for water hardness and the
laundry.
Washing performance is poor:
Stains persist or the laundry is
not whitened. (**)
Insufficient amount of detergent is used. • Use the recommended amount of detergent
approprate for water hardness and the
laundry.
Excessive laundry was loaded in. • Do not load the machne n excess. Load wth
amounts recommended n the "Programme
and consumpton table".
Wrong programme and temperature were
selected.
• Select the proper programme and
temperature for the laundry to be washed.
Wrong type of detergent is used. • Use orgnal detergent approprate for the
machne.
Too much detergent is used. • Put the detergent n the correct
compartment. Do not mx the bleachng
agent and the detergent wth each other.