Flavel WFA6100W - Page 25

Washing Machine / User’s Manual
25 / EN
Problem Reason Soluton
Too much foam forms in the
machine. (**)
Improper detergents for the washing machine are
being used.
• Use detergents approprate for the washng
machne.
Excessive amount of detergent is used. • Use only suffcent amount of detergent.
Detergent was stored under improper conditions. • Store detergent n a closed and dry locaton.
Do not store n excessvely hot places.
Some meshed laundry such as tulle may foam too
much because of their texture.
• Use smaller amounts of detergent for ths
type of tem.
Detergent is put in the wrong compartment. • Put the detergent n the correct
compartment.
Softener is being taken early. • There may be problem n the valves or n the
detergent dspenser. Call the Authorsed
Servce Agent.
Foam is overflowing from the
detergent drawer.
Too much detergent is used. • Mx 1 tablespoonful softener and ½ l water
and pour nto the man wash compartment of
the detergent drawer.
• Put detergent nto the machne sutable
for the programmes and maxmum
loads ndcated n the “Programme and
consumpton table”. When you use addtonal
chemcals (stan removers, bleachs and etc),
reduce the amount of detergent.
Laundry remains wet at the end
of the programme. (*)
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent usage.
• Use recommended amount of detergent.
(*) Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the
machine and to its surrounding environment. Laundry should be rearranged and re-spun.
(**) Regular drum cleaning is not applied. Clean the drum regularly. See 4.4.2
A
CAUTION: If you cannot eliminate the problem although you follow the instructions in this section, consult your
dealer or the Authorised Service Agent. Never try to repair a nonfunctional product yourself.