Quick Connectors
Removal
1. To release a pipe from a quick connector, push on both sides of the
blue collar.
2. With the collar oushed in, pull the pipe from the connector.
Replacement
1. To replace a pipe into a quick connector, simply push in the pipe.
The pipe should be inserted 15mm to ensure a good connection.
Compression fittings
Removal
1. To release a pipe from a compression fitting use a 12mm, 13mm or
14mm spanner (dependent on fitting) to loosen the end cap.
2. Pipe can be pulled out.
3. The use of two spanners maybe required if the compression fitting is
to be replaced.
Troubleshooting
16
To Next Page
Loading...