ASSEMBLING YOUR KOMBI RANGER MARKER
PREPARING FOR USE
1. Carefully remove the machine and accessories from packaging.
2. Insert handlebar section; adjust to suit user’s height and tighten using thumb
screws.
3. Bar ends can be adjusted to suit hand position using the supplied 5mm allen
key.
4. Connect switch using the coiled power cable. (Fig 1)
5. Lift bonnet, take out packing wedge and remove docking battery.
6. Position machine near a 230/240V AC power supply, dock the battery and
switch on. (Fig 2)
CAUTION. Only use the supplied charger. Use of other equipment
may cause fire or damage the battery. Maintain battery charge at all
times, charge once a month if stored for long periods without use.
(Fig 2) (Fig 3)
7. When charging the LED on the charger illuminates red. When the battery is
fully charged, the LED illuminates green. Once green, remain charging for a
futher 60 minutes, a full charge can take 4-6 hours on average.
8. Once charged, dock battery within the machine. Battery status can be
monitored by using the LED display on the battery.
Assembly
2
To Next Page
Loading...