CHASSIS AND VEHICLE
IDENTIFICATION
Several numbers are used to identify the vehicle
and components used on the vehicle.
The V.I.N. or
Vehicle Identification Number is
assigned by the chassis manufacturer and is the
number used for vehicle registration. The Y.I.N.
is found on the Federal Certification Tag attached
in the driver's compartment. Refer to this
infor-
mation when ordering parts from the chassis
manufacturer or chassis dealer service center.
The F.I.N. or
Fleetwood Identification Number
is located on the tag just outside the main entry
door or on the outside left front side
of
the motor
home.
Use this number when ordering parts
through your Fleetwood dealer or Service Center.
(Example)
FEDERAL CERTIFICATION TAG
MFD
BY:
DATE
MFD:
INC
VEH
MFD
BY:
DATE
OF
VEH
MFD:
GVWR:
KGS
(
LBS)
FRONTGAWR:
KGS
(
LBS)
WITH:
RIMS
TIRES
AT:
KPA
COLD
SINGLE
(
PSI)
INTERMEDIATE
KGS
(
LBS)
GAWR:
WITH:
RIMS
TIRES
AT:
KPA
COLD
DUAL
(
PSI)
GAWR
REAR:
KGS
(
LBS)
WITH:
RIMS
TIRES
AT:
KPA
COLD
SINGLE
(
PSI)
GAWR
COMBINED
INTERMEDIATE
AND
REAR:
KGS
(
LBS)
This
vehicle
conforms
to
all
applicable
U.S.
Federal
Motor
Vehicle
Safety
Standards
in
effect
on
the
date
of
manufactUre
shown
above:
V.I.N.
TYPE
VEHICLE:
MULTI-PURPOSE
PASSENGER
VEHICLE
The
tires
and
wheels
with
sizes
and
ratings
designated
above
have
been
equipped
with
this
vehicle
by
Fleetwood.
Any
replacement
tires
installed
must
meet
the
same
specifications
and
minimum
load
requirements.
W15-0016
Located in the driver's compartment.
Introduction
SUSPENSION ALIGNMENT
AND
TIRE BALANCE
The front suspension and steering system
of
this
vehicle was accurately aligned at the factory
before delivery to the dealership_ However, after
you have fully loaded the vehicle according to
your personal needs, have the alignment
checked and adjusted,
if
necessary.
To
help pre-
vent uneven tire wear, check the front -end align-
ment periodically_
Please note that front-end alignment after
retail delivery is the owner's responsibility
and
is
not
covered under the warranty.
(Example)
FLEElWOOD.
MOTOR
HOMES
OF
PLAN
APPROVAL
NO.
-
F.I.N.
MFD.ID.
NO.
DATE
OF
MFA.
MO:
INC.
MODEL
YR:
Located on the exterior left front side
of
the motor home.
- F.I.N. (Fleetwood Identification No.)
01-3
I~
To Next Page
Loading...
Need help?
General
