3
MAINTENANCE AND TROUBLE SHOOTINGMAINTENANCE AND TROUBLE SHOOTING
MAINTENANCE AND TROUBLE SHOOTINGMAINTENANCE AND TROUBLE SHOOTING
MAINTENANCE AND TROUBLE SHOOTING
Does not fire point.
MAGAZINEMAGAZINE
MAGAZINEMAGAZINE
MAGAZINE empty. Reload stack of points.
Point jammed. Remove points. Remove screw
(E)(E)
(E)(E)
(E), and pull
PROBLEMPROBLEM
PROBLEMPROBLEM
PROBLEM
PROBABLE CAUSEPROBABLE CAUSE
PROBABLE CAUSEPROBABLE CAUSE
PROBABLE CAUSE
CORRECTIONCORRECTION
CORRECTIONCORRECTION
CORRECTION
MAGAZINE MAGAZINE
MAGAZINE MAGAZINE
MAGAZINE out of driver. Discard jammed
point.
Magazine locking screw
(E) (E)
(E) (E)
(E) Tighten screw and nut firmly.
loose.
Fires 2 points at Magazine locking screw
(E) (E)
(E) (E)
(E) Tighten screw and nut firmly.
once. loose.
Point penetration Frame not firmly backed up Support the frame and hold the point driver
not deep enough. and point driver not held tightly against the wood.
tight against the wood.
Pressure adjustment too low. Turn the
ADJUSTABLE KNOBADJUSTABLE KNOB
ADJUSTABLE KNOBADJUSTABLE KNOB
ADJUSTABLE KNOB
(D) (D)
(D) (D)
(D) clockwise.
NONO
NONO
NO
..
..
.
ORDER #ORDER #
ORDER #ORDER #
ORDER #
PART NAMEPART NAME
PART NAMEPART NAME
PART NAME
QTY.QTY.
QTY.QTY.
QTY.
NO. ORDER #NO. ORDER #
NO. ORDER #NO. ORDER #
NO. ORDER #
PART NAMEPART NAME
PART NAMEPART NAME
PART NAME
QTYQTY
QTYQTY
QTY.
1 12-900 Handle (Right Hand)1 14 12-713 Spring Stop Plate 1
2 12-901 Handle (Left Hand) 1 15 12-714 Main Spring 1
3 12-902 Trigger Assembly 1 16 12-715 Guide Pin 3
4 12-732 Magazine Assembly 1 17 12-716 Adjustable Knob 1
5 12-704 Follower Assembly 1 18 12-717 Square Nut 1
6 12-904 Channel 1 19 12-718 Washer 1
7 12-905 Push Plate 1 20 12-719 Follower Spring 1
8 12-707 Bumper 1 21 12-720 Cap 1
9 12-708 Stop Bar 1 22 12-721 Trigger Spring 1
10 12-709 Hammer 1 23 12-722 Pan Head Screw 2
11 12-710 Pawl 1 24 12-723 Plastite Screw 3
12 12-711 Pawl Pin 1 25 12-731 Magazine Screw 1
13 12-712 Torsion Spring 1 26 12-725 Magazine Nut 1
To Next Page
Loading...