Flex-a-Lite 32050 User Manual

1. Using threaded adapters if necessary (included), screw the sensor into the desired
location using Teflon tape to seal the threads. Use Flex-a-lite part no. 32082 (1½” diameter)
or 32084 (1¾” diameter) to mount sensor inline with radiator hose (Preferred location - see
Detail A). Alternatively, the sensor can be mounted in the intake manifold (see Detail
B) or cylinder head or block (see Detail C). Do NOT overtighten.
2. Carefully strip the ends of the wires. Fold the wire back on itself to effectively double
the thickness (
see Detail D). Using a quality crimping tool, crimp the female connectors
provided on the ends. Attach the wires to terminals 10 & 11 on the VSC (it doesn’t matter
which wire goes to which spade, but both wires must be connected). Make sure the temp.
sensor wires are at least 2-3” away from exhaust manifolds or other extreme heat
sources.
3. Start the vehicle and check for leaks. When the engine has reached desired operating
temperature, adjust the VSC to turn the fan(s) on (see page 2).
Detail A
Detail B
Important:
Before beginning, be sure that the Variable Speed Control unit (VSC) is mounted close enough
to the temperature sensor so that the wires will reach the control unit. The lead on the sensor is
approximately 4 feet.
Installation Instructions
Screw-in Temperature Sensor #32050
(To be used with Flex-a-lite Variable Speed Control)
Page 1 of 2 part no. 99163

Flex-a-Lite 32050 Specifications

General

Brand	Flex-a-Lite
Model	32050
Category	Accessories
Language	English

Summary

Screw-in Temperature Sensor Installation

Pre-Installation Checks

Ensure VSC unit is close to sensor, wire reach, and sensor lead length.

Mounting and Sealing

Screw sensor into location using Teflon tape; preferred radiator hose mount.

Wiring Connections

Strip and crimp wires, connect to VSC terminals 10 & 11; keep wires away from heat.

Leak Check

Start vehicle and check for leaks after installation.

Variable Speed Control Adjustment

Temperature Verification

Confirm engine has reached operating temperature by checking radiator hose.

Fan Activation Adjustment

Adjust VSC screw counterclockwise until fans cycle on for desired temperature.

Adjustment Screw Limits & Operation

Note maximum ¼ turn adjustment; turning beyond limits damages the unit.

Performance Monitoring

Ensure fans cycle correctly to maintain temperature; check LEDs L1 and L4.