Flex BW 18.0-EC Operating Manual

BW 18.0-EC
17
Instructions for use
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Attaching the nozzle
WARNING!
Remove the battery before carrying out any
work on the power tool.
Assemble
 Attach the nozzle to the bayonet
connection by turning lightly in anti-
clockwise direction.
 Check that the adapter is securely
seated!
Disassemble
 Remove in reverse order.

Flex BW 18.0-EC Specifications

General

Battery Voltage	18 V
Voltage	18 V
Housing Material	Plastic
Airflow speed	82 m/s
Max. air speed	82 m/s