Flex BW 18.0-EC - Page 18

BW 18.0-EC
19
 To switch off, briefly press and release
theswitch.
Speed selection
The speed can be preselected in 3 stages
between 10,600 and 18,000 rpm.
Working with the power tool
CAUTION!
When it is switched off, the blower continues
to run briefly.
Air sweeping
1. Fit the nozzle.
2. Insert battery.
3. Set the speed to the required setting.
4. Hold the power tool with one hand on
the handle and assume the working
position.
5. Switch on thepower tool.
At the end of work:
6. Release the switch.
Inflating
1. Fit the adapter with suitable reducing
nozzle on the bayonet connection.
2. Insert battery.
3. Attach the reducing nozzle, ensuring
an exact fit.
4. Set the speed to the required setting.
5. Hold the power tool with one hand on
the handle and assume the working
position.
6. Switch on thepower tool.
At the end of work:
7. Release the switch.
Deflating
1. Fit the adapter with suitable reducing
nozzle on the air inlet.
2. Insert battery.