Flex BW 18.0-EC User Manual

BW 18.0-EC Instruction manual
9
Operating instructions
WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
Before switching on the power
tool
Unpack the power tool and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.
Inserting/replacing the battery
1. Press the charged battery into the
power tool until it clicks into place.
2. To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
1. Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Attaching the nozzle
Attaching
1. Attach the nozzle to the bayonet
connection by turning lightly in anti-
clockwise direction.
2. Check that the adapter is securely
seated!
Detaching
1. Remove in reverse order.

Flex BW 18.0-EC Specifications

General

Battery Voltage	18 V
Voltage	18 V
Housing Material	Plastic
Airflow speed	82 m/s
Max. air speed	82 m/s