Instruction manual LW 1503
12
2. To lock the switch in the "ON"
position: with the switch "ON", press
the front end of the switch button (L)
Fig. 8, in toward the tool housing.
To release the switch lock, press the
back end of the switch button in
toward the tool housing.
Using the power tool
DANGER
When using the tool for a horizontal
application, work the tool as shown
in Fig. 9.
When using the tool for a vertical appli-
cation, work the tool as shown in
Fig. 10.
DO NOT use the tool in an excessive
vertical application. Excessive vertical
use can lead to water and debris entry
to the motor through air intake (O)
as shown in Fig. 11.
1. Attach polishing tool.
2. Connect machine to the power
supply.
3. Connect the water.
4. Switch on the machine.
5. Open shut-off valve on the water
connection.
6. Firmly grip the bail handle and motor
housing as shown in Fig. 12.
7. Lower the tool until the polishing disc
contacts the work. Use light
pressure.
To Next Page
Loading...
Need help?
General
