What to do if I notice low air flow rate in my Flexit Air Handlers?
If you're experiencing low airflow with your Flexit Air Handlers unit, first verify the unit's speed setting. Also, ensure that the filters are properly sealed and check the intake grille for any obstructions. The thermostat (F10) may need to be manually reset by pressing the reset button.
Why are the fans not working in my Flexit Air Handlers?
If the fans in your Flexit Air Handlers aren't working, start by confirming that the unit is receiving power. Then, check if the overheating thermostat has tripped. If it has, reset it by pressing the button, and also reset it in the app or on the control panel.
How to stop cold draughts from Flexit Air Handlers?
If you are feeling cold draughts from your Flexit Air Handlers, verify the selected supply temperature on the control panel. Also, check that the rotor is rotating and confirm that the heating is active.
Control the ventilation unit via smartphone/tablet.
Control panel accessory for the ventilation unit.
Fans ensure air enters and leaves the building.
Filters ensure clean supply and extract air for the unit.
Rotary wheel-type heat exchanger for heat transfer.
Electric heating element to raise supply air temperature.
Four sensors register air temperatures for unit operation.
Dampers control airflow in exhaust and outdoor air ducts.
Instructions for removing the unit door, including weight warning.
Clean fan blades with grease solvent and compressed air annually.
Replace filters annually, or more often in dusty environments.
Replace or adjust brush strips on the rotor if worn.
Clean rotor with a soft brush or solvent; ensure motor is protected from water.
Clean exterior with a soft cloth, warm water, and neutral detergent.
General| Brand | Flexit |
|---|---|
| Model | Nordic S2 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
