Document Title Document No. Revision
Date Section
Supplement S3 to the AMM CTLS-LSA –
CTLS-LSA with ROTAX 912iS
AF 0480 0011 02 16-Jul-14 01-00-1
Approval Ref.: Approved on the Basis of Manufacturer Self Declaration
01-00.2 Approval
The contents of this manual is approved on the basis of Manufacturer Self Declaration
against the applicable ASTM industry standard.
01-00.3 Certification Basis
The engines Rotax 912 iS and iS Sport are in compliance with ASTM F2339. The engine
Rotax 912 iSc Sport is Type Certified in compliance with CS-E Amdt. 3.
The engine installation to the airframe is in compliance with ASTM F2245.
This supplement to the AMM is generated in compliance with ASTM F2483, and is part of
the Required Product Information per ASTM F2745.
The revision level of the standards applicable to the specific S/N is identified on the
aircraft’s Statement of Compliance.
01-00.4 Manufacturer Contact
The aircraft is manufactured by:
Flight Design GmbH
Zum Tower 4
01917 Kamenz
Germany
Web: www.flightdesign.com
e-mail: info@flightdesign.com
01-00.5 Recovery of Certification Data
If the original manufacturer will lose the ability to support the make and model of this
aircraft, you can recover certification documentation through the following contact:
EUA Engineering Ukraine Ltd.
Rabochaya 82a
73000 Kherson
Ukraine
01-00.6 General Safety Information
Consider the following warnings to avoid unnecessary risks while you carry out
maintenance of the aircraft:
▲Warning: Only the personnel with adequate qualification may carry out an
inspection and maintenance work.
▲Warning: You shall carry out inspection and maintenance in accordance with
respective national safety requirements.
▲Warning: Before you begin any work, you shall read and understand all relevant
sections of this AMM. In case of any doubt or missing information you
shall first contact the manufacturer for advice.
▲Warning: Consider the safety notes in this supplement as unconditional.
To Next Page
Loading...
