FlightScope Mevo+ - Connect to Mevo+ (Manually)

Connect manually (via Wi-Fi)
5
4
3
2
1
Make sure your phone’s Wi-Fi is turned on.
Press the on/off button on the unit, the system and battery lights will come on.
The connection light will be solid blue while the unit is ready for connection.
Select Wi-Fi settings on your phone and select the unit with your serial number.
The Wi-Fi password is your serial number, for example: M2-123456.
The connection light on the the unit will turn to solid green when connection has
been established.
Launch the app on your phone and proceed.
If you are unable to connect using the QR code, then you can connect
manually in your device settings. Follow these easy steps:
1
1
2
2
3
3
4
4
5
5
13