Flip-Pal 100C Quick Start Guide

Quick Start Guide
Quick Start Guide for Mobile Scanner- Flip-Pal
®
100C
1 Introduction
Scanner Top (scanning side)
2 What’s In the Box?
 Flip-Pal
®
Model 100C mobile scanner
 Four AA batteries (installed)
 2GB SD memory card (installed) which stores
your scans and contains the Flip-Pal
®
Software
 SD Memory Card to USB adaptor
 Quick Start Guide
3 Set Up
Activate the Batteries
Power on the Scanner
Set Date and Time
At initial power up or battery
change, you will see this
screen.
Use UP ARROW and DOWN
ARROW to change the value of
each field. Use LEFT ARROW and RIGHT ARROW to
scroll to each of the fields in turn, beginning with Month
and ending with AM/PM. When you are satisfied with all
settings, move the cursor to Done and press OK.
Note: If you press the green scan button when you
first see this screen, you can skip the date and time
setting process. Your scans will have factory-set time
and date.
Viewing Window for Flip and Scan
Battery Compartment
Business Card Pocket
Slide power switch toward
rear, hold until the display
lights up, then release
Press gently on battery
door while pulling tab
sideways to remove
Scanner Bed
Removable Lid
SD Memory Card Slot
Scan Button
Power Switch
Display
UP, DOWN, RIGHT, LEFT ARROW Buttons
OK Button (center)
Photo Guide
Scanner Bottom (viewing side)

Flip-Pal 100C Specifications

General

Brand	Flip-Pal
Model	100C
Category	Scanner
Language	English