Two Device Universal
Instruction Manual
Table of Contents
Use two (2) new AAA batteries. Please see the following
instruction when installing the batteries.
Batter y Installation
1. Open the battery cover in the back of the remote as
illustrated.
2. Match the batteries to the + and - marks inside the battery
case, then insert the batteries. If the installation is correct,
the indicator light will flash 2 times.
3. Put the battery cover back on.
4. Press any key, if the indicator light flashes, installation is
correct.
Warnings:
1. Do not mix new batteries with old ones or place the
batteries incorrectly.
1
Introduction
Functions
Set Up
Step 1: TV set up
Step 2: Set Top Box (STB)
Step 3: Favorite Channels
Step 4: Dual Mode (TV & STB)
Step 5: Lock
ON / OFF Options
TV Only
STB Only
Channel Entry Options
Other Set-up Options
Automatic Code Searching
Learning Set Up
Troubleshooting
Code Retrieval
Reset the Remote
TV Brand Code List
STB Brand Code List
--------------------------------------------- 2
------------------------------------------------- 2
---------------------------------------------------- 3
------------------------------------- 3
------------------------- 4
-------------------------- 4
------------------- 6
----------------------------------------- 7
--------------------------------------- 7
---------------------------------------------- 7
-------------------------------------------- 8
--------------------------------- 8
----------------------------------- 9
------------------------- 9
------------------------------------ 10
--------------------------------------- 11
----------------------------------------- 11
--------------------------------------- 12
------------------------------------ 13
--------------------------------- 19
© Flipper LC 2009. US Patent Pending
Support: www.FlipperRemote.com
®
F
L
I
P
P
E
R
To Next Page
Need help?
General
