4
FLIR
BREACH
USER MANUAL
SAFETY STATEMENT
• Read and follow all instructions
• Read all warnings
• Only use the attachments/accessories specified by the manufacturer
• All service must be provided by the manufacturer
WARNING:
DO NOT DISASSEMBLE THE DEVICE.
Disassembly can cause permanent damage and void the warranty.
WARNING:
This product contains natural rubber latex, which may cause
allergic reactions!
CAUTION:
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
CAUTION:
• Do not point the camera at high-intensity radiation sources such as
the sun, lasers, or arc welders
• Do not leave fingerprints on the camera’s infrared optics. Clean only
with low pressure fresh water and a lens cloth
• Keep the equipment clean. Protect it from moisture, dramatic
temperature drops, and electrical shocks
• DO NOT force the equipment controls past their stopping points
• DO NOT leave the equipment activated during breaks in operation
• DO NOT store the equipment with the batteries installed
• Thoroughly clean and dry each item before placing them into the
storage case
NOTES:
• To avoid losing unsaved data, DO NOT remove the batteries or
disconnect the external power source while the product is on
• Inadvertent sun damage is not considered a defect in material or
workmanship, and is therefore not covered in the product warranty
Breach
TM
Thermal Monocular
The Breach thermal imaging monocular is used as a handheld viewer,
and it has the ability to save an image or a video clip.
Nevertheless, in the industry and throughout this manual, this type of
device is also referred to as a camera.
To Next Page
Loading...
